The Fenix E03R V2.0 is the successor to the successful miniature rechargeable flashlight that fits easily on your key ring or in a woman's handbag. Despite its minimal size and weight of just 30 grams, it provides a high luminous flux of up to 500 lumens (ANSI) and a beam that illuminates a wide area uniformly up to 90 metres. Power is provided by a built-in 400 mAh Li-pol battery, which can be charged via the modern USB-C connector on the side of the lamp. A total of four white light modes and two red light modes are available, with up to 30 hours on the lowest mode. A unique new feature is the so-called Breathing light, a pulsating light with 1 lumen around the switch button, which can be used for unobtrusive signalling or to locate the flashlight. The flashlight is equipped with a key ring so it's always at hand. A handy feature is the battery charge indicator built into the button. You can always delight with this useful gift. All the parameters of the lamp (luminous flux, battery life, water resistance, range and impact resistance) are measured according to ANSI/NEMA FL 1-2009 standard PARAMETERS OF THE FENIX E03R V2.0 TELEPHONE LAMP Two white MATCH CA18 LEDs and red Everlight 2835 LED light source are used. Both with 50 000 hours of illumination life. Four white light modes: 500 lumens (1.3 hours) -> 150 lumens (2 hours) -> 30 lumens (6.5 hours) -> 5 lumens (30 hours). Two red light modes: 5 lumens -> red flashing (5 lumens) Pulsating light around the switch button 1 lumen (Breathing light). The light is powered by a built-in rechargeable lithium polymer battery with 400 mAh capacity. Battery charge status indicator on the button. Charging via the modern USB-C connector. Mode memory for last used white light mode. Intelligent overheat protection. CNC etched aluminium alloy body - Type III hard anodized with scratch resistant surface. Dimensions 5.25 cm (length) x 2.6 cm (width) x 1.3 cm (height). Range 90 metres (2082 cd). Weight 30 grams (including battery). IP66 water resistance (water spray from all directions). Impact resistant to drops from a height of 1 meter. Includes metal key ring and USB-C charging cable. Available with USB-C cable, colour USB-C cable or micro-USB USB-C adapter. USE To switch on or off, press and hold the side button for approximately 0.5 seconds. To turn on the red light, press and hold the button for 1.2 seconds. The modes can be switched at any time during operation by briefly pressing the side button. To switch on the Breathing light, press the button of the switched-off light twice in quick succession. The control button can be locked to prevent it from turning on by itself, e.g. when transporting in a parcel - hold the button down for 3 seconds. The light will flash twice to indicate that the lock has been activated. To unlock, hold the button down for 3 seconds in the same way. Battery charge indicator - when the torch is off, press the button briefly once and the small LED on the button will light up for 3 seconds. A green light indicates that the battery is 100-85% charged , green flashes 85-50% , red light indicates that the battery is 50-25% charged and red flashes indicate that the battery is less than 25% charged. Intelligent overheating protection - if the lamp temperature exceeds 60°C, the lamp automatically reduces power. As soon as the lamp temperature cools down below 60°C, the highest mode can be used again. Low battery indicator - the lamp gradually switches to the lowest mode and the indicator in the button starts flashing red. Connect the flashlight to a computer, USB power adapter or USB car adapter using the USB-C cable. Alternatively, any mobile phone charger with a USB-C connector can be used for charging. The indicator LED on the button turns red when charging and green when fully charged. Charging time for a fully discharged battery is approximately 2 hours. The Li-pol battery does not suffer from memory effect, so the lamp can be recharged at any time. After each charge, close the cover of the USB connector tightly. WARNING Do not disassemble the sealed parts yourself, this will void the warranty. In wet environments, make sure that the USB-C connector cover fits properly into the flashlight. If the flashlight does not switch to higher power mode or does not light up, the battery is dead - charge the flashlight.