The FITalco START is characterised by the accuracy of the measurements and a number of additional functions. The backlit display allows you to measure alcohol consumption at night. The breathalyser measures without a mouthpiece, making it extremely convenient to use. However, the absence of a mouthpiece may affect the accuracy of the measurements (e.g. depending on the distance of the breathalyser from the mouth, the force and direction of the blow), so for measurements in situations where the answer depends on an accurate result (e.g. applied control), we recommend hand-held meters with mouthpieces of the alcohol measuring series.The results are shown on the display in two units of millilitres and mg/l, so there is no need to convert the measurement obtained.The time required to prepare the alcohol probe for the first measurement is only 10 seconds, so you can take the measurement almost immediately after switching it on.The audible alarm always informs you when to start and stop the measurement.Using the FITalco START breathalyser is very simple. The measurement is performed after pressing the TEST button. After the word "Blow" appears on the display, blow air into the device from a distance of 1.2 cm for about 4 seconds.TECHNICAL SPECIFICATIONSPage informationNo calibrationMeasurement accuracy [‰] 0,01Calibration possible YesOperating temperature [°C] 0 to 40No mouthpiece requiredMeasuring range [‰] 0 to 2Alcohol meter for private usePower AAA x 2Further dataMeasuring time [s] 4 to 10 minDominant colour whiteAdditional colour silverLCD display is availableDimensionsThickness [mm] 14Weight [g] 30.5Total width [mm] 35Total height [mm] 95