DESCRIPTION AND PARAMETERS The VISIO Light lighting collar is designed for the safety of dogs. The light tube can be adjusted to the circumference of the dog's neck (min. Length approx. 20 cm, max. Length approx. 70 cm). Visio Light is not specifically a collar! Depending on the state of charge of the battery and the conditions of the site, the illuminated hoop can be seen from up to 500 m. It can also be set to flash or continuous lighting (using the toggle switch). The device is made of drip-proof and high-quality material. No battery required: instead, the device can be charged from a device with a USB port, such as a computer, using a standard USB cable. Accessories: 1 light neck ring 1 USB cable Safety: Before using the device, read and save the instructions below so that you can read them again later if necessary. If you give the device to someone, add the user guide as well. To get started with Visio Light: Before using Visio Light, read the user manual carefully and make sure you follow the step-by-step instructions. Carefully remove Visio Light from its packaging to protect it from damage. Connect the included USB cable to the tube (using the small connector) and connect it to a USB port, such as a computer. The LED next to the Toggle Switch will turn off when the device is fully charged. Use only the USB cable provided with the device to charge Visio Light. The charging time is approx. 90 minutes to 2 hours. Fit Visio Light to your favorite neck. To do this, first measure the circumference of your pet’s neck. Place a tape measure around your pet’s neck and measure its perimeter so that the tape measure is not too tight and two fingers fit easily between the neck and the tape measure, this way you can ensure that the Visio Light fits perfectly. Mark the appropriate size on the Visio Light and cut with a sharp scissors behind an LED: as shown in Figure 3. Put the closing end back on the tube: as shown in figure 4. Visio Light is now ready for use. Use the toggle switch to set different lighting modes: Continuous lighting Fast flashing Slow flashing Note: Visio Light can illuminate for approximately 90 minutes in continuous lighting mode and for approximately 2 hours in flashing mode before recharging. Cleaning the Visio Light: The light tube can be wiped clean with a soft, dry cloth. Danger to children and certain people: The device should NOT be used as intended by children, people with reduced physical, sensory or mental capabilities, or those who have no experience and / or knowledge of using the device, unless it is used under the supervision of a person who constantly monitors and takes responsibility for their safety or guidance. they get the device. Children should be supervised to ensure that they do not play with the appliance. Keep out of the reach of children. Risk of suffocation if swallowed. Product packaging is not can be pulled over the head. Risk of injury or damage to property: Protect from heat. Maximum ambient temperature -10 ° C / + 40 ° C Protect the product from physical injury due to impact or fall. Do not use abrasive or abrasive cleaners that can damage the surface of the product. Check the condition of the product before use. Do not use a defective device. Dangers of battery charging: Only use a charging station that is suitable for charging with lithium polymer batteries. Improper battery charging (excessive voltage, excessive temperature, electricity, or poor charger) can result in overheating, explosion, or fire. Do not charge the battery near a heat source or in a poorly insulated car. High temperatures can cause the battery to malfunction, which can lead to overheating, explosion, or fire. Due to the large amount of energy storage, lithium polymer cells can become hot or explode if damaged. This can occur due to extreme overcharging, overloading, dropping, mechanical damage, etc. also. For this reason, it is important to monitor the charging process. Electrical hazard: The device is designed to run on battery power (rechargeable battery). Meets your specifications. Never use the device with a type other than the recommended power supply: due to the risk of short circuit or electric shock. Do not continue to use the luminous neck ring if it falls into the water. Do not continue to use the product if it is damaged or dropped. Through a service center only improve to prevent risks. (Please note the warranty conditions) Failure / error: Does not work? Is the battery not charged? Connect the USB cable to the fluorescent lamp and charge the battery. Also, make sure your computer's USB port is working. Technical data: Battery: 1 x 3.7 V- 100 mA

1 st